FX wall mounted water penstock
FX series

Wall mounted water penstock

Max size
118.1” x 118.1”
Maximum size
Working head
32.8 FT
Working head
Max temperature
176°F
Temperature
Seal
Bidirectional
One-piece profile
Seal
FX series header
FX wall mounted water penstock
FX penstock

One continuous profile

The Arnett Valve FX is a welded assembly penstock for water service, used for isolation and flow control. The seal profile runs as a single piece. At the upper corners it curves, so those corners are part of the same continuous profile and carry no joints. The penstock seals with the head on either face as standard.

FX seal profile
Bidirectional as standardSeals with the head on either face.
One-piece seal profileCurved through the upper corners, so the corners carry no joints.
High flow, low pressure dropThe raised gate leaves the opening clear.
Rising or non-rising spindleBoth configurations, with extensions for remote operation.
Interchangeable actuationActuators swap with the penstock in place.
Built for civil worksDesigned to the opening, the head and the operating position.

Standard envelope

To 118.1” x 118.1”, 32.8 ft head.

Sizes
Up to 118.1” x 118.1”
Working head
32.8 ft
Higher head on request
Temperature
Up to 176°F
Seal
Bidirectional
One-piece profile
Service
On/off and modulating
Mounting
Channel, embedded in concrete, or wall-anchored

Every FX is designed for the customer's civil works. Sizes, head and materials outside the standard envelope: consult Arnett.

Materials and construction

Welded assembly. Epoxy coating on carbon steel components.

RangeMaterials
Standard rangeCarbon steel, SS304, SS304L, SS316, SS316L
For seawaterDuplex, Superduplex

Special materials and treatments on request.

Standards and directives

Design to AWWA standards.

Pressure Equipment Directive PED 2014/68/EU, Article 4 Paragraph 3.

Machinery Directive 2006/42/EC.

Explosive Atmosphere Directive ATEX 2014/34/EU, Category 3, Zone 2 and 22.

Finite Element Analysis on components and assemblies.

One penstock, five actuators

Actuator typePower source
HandwheelManual
GearboxManual
ElectricElectric
Pneumatic cylinderCompressed air
Hydraulic cylinderHydraulic

Actuators interchange with the penstock in place. ISO 5210 drilling in most cases. Other actuation options on request. Rising or non-rising spindle. On/off and modulating service.

Actuator on the penstock

Applications

Mining and mineral processing

Built for civil works

Every FX penstock is designed to the opening, the head and the operating position it will live in. The standard envelope runs to 118.1” x 118.1” and 32.8 ft of head. Higher head is available on request.

TypeWhere
Channel passageAnchored in the channel section
EmbeddedCast into the concrete during commissioning
Wall-anchoredBolted to the wall with anchor bolts and wall fixing connectors
FX penstock, spindle and actuator detail
FX

Configuration options

Rising or non-rising spindle
Spindle extensions for remote operation
Floor stands to the installation
Wall fixing connectors and anchor bolts
Duplex and superduplex for seawater service
Special materials and treatments on request
Higher working head on request

Duties outside this envelope: Arnett engineers custom builds. Consult Arnett.

Contact Arnett

Call, send an email or fill in the form. An Arnett engineer replies with a quote and a recommended model.